Use in motorsport
When compared to a conventional solution, 3D printing was found to involve less work and to produce a more lightweight part.
Wear-resistant parts with considerably improved wear resistance compared to standard 3D printing materials are manufactured using special filaments and SLS powder from igus®. Further benefits at a glance:
Similar wear-resistant properties to classic injection moulded parts made of iglidur®
More than 30 years of experience in the development of high-performance plastics for moving applications
Tested in the company's own laboratory
3D printing service - simple, fast & with full cost transparency, in as little as 24 hours
wear test swivelling
Surface pressure: 1MPa
Surface speed: 0.01m/s
Pivoting angle: 60°
Duration: four weeks
Shaft materials: CF53 and 304 SS
Y = Wear rate [μm/km]
A = ABS printed B = iglidur® I180 printed C = iglidur® I170 printed D = iglidur® J260 printed E = iglidur® J260 injection-moulded
Excellent wear behaviour
Tested service life
Low coefficient of friction
For prototypes or low volume production.
Wear-resistant and low coefficient of friction
Good mechanical properties
Detail accuracy with precise surfaces
Can be processed in a similar way to commercially available SLS materials
Pondělí až pátek od 7:00 do 20:00.Sobota od 8:00 do 12:00.